36KW TP Touch Screen Industrial Drying Oven

TP Touch Screen Leveling Drying Oven

For baking glass cover ink after printing

After printing, the glass is loaded into trays, heated and cooled by a conveying furnace, and then collected manually.

The conveying furnace is heated by circulating air and stainless steel heater. The surface temperature of common materials is 180℃, and the temperature uniformity in the furnace is within ±3%.

Equipment overview
For baking printing ink on glass surface
The material is discharged after being heated and cooled by the conveyor belt through the infrared drying oven
The infrared drying oven is heated by infrared, the surface temperature of common materials is 180 ℃, and the surface temperature of the materials is uniform within 3 +/- 3 ℃.

Equipment specifications and main technical indicators

Delivery method
1. It is conveyed by beige Teflon cloth conveyor belt with a net width of 900mm.
2. There is an automatic adjustment mechanism for net deviation and limit protection.
3. Adopt the frequency converter to freely adjust the stepless speed, the speed range is 0.2-5m/min.
4. High-grade fully enclosed gear reducer motor drive.
5. Install a sticky paper roll at the bottom of the feed inlet to clean the conveyor belt.

Structure distribution
1. External dimensions: L6000mm×W1760mm×H1650mm
2. Feeding section 500mm
3. Heating section 4000mm (2 temperature zones are divided equally)
4. Cooling section 1000mm
5. Discharge section 500mm
6. The height of the conveyor belt from the ground is 950±20mm

Other project parameters:
1. Material quality: SS41# steel plate is used inside and outside, after anti-rust treatment, electrostatic spray 60# light sand color.
2. Control mode: PLC + touch screen control, stand-alone work without MES interface, with energy-saving mode, the feeding position is equipped with a material detection photoelectric switch, the UV light is automatically turned on when it detects that the material enters, and the material is automatically turned off after the delay
3. Use environment: ambient temperature 10-40℃, relative humidity 20%-80%RH.